Remote Debugging
Debugging the kernel on LAN
Last updated
Debugging the kernel on LAN
Last updated
Remote debugging allows you to remotely diagnose the kernel live. It uses TCP networking to listen to the configurable port.
If remote debugging is enabled on your kernel configuration, it starts the remote debugger under the following configuration (for those who use the firewall):
Socket: TCP
Port: 3014 (configurable)
Transfer: Inbound and Outbound
Once the remote debugger starts, you can connect to it using the raw TCP connection to the server. To initiate the connection, select a platform:
Host Name (or IP address): Host of the remote debugger
Port: 3014 (configurable)
Type: Raw
Click on Connect or Open and you should be able to see debugging messages from the remote host.
You can use the nc (netcat) command to connect to a remote debugger using a raw connection. Execute the command in this form: nc <host> <port>︎, where:
<host>: Host of the remote debugger
<port>: 3014 (configurable)
You should be able to see debugging messages once the connection to the remote debugger has been established.
The chatting feature was added to the remote debugger to allow chatting with the other users debugging the same kernel to discuss what is happening in the kernel.
Every device connected to the remote debugger using the provided connection information will have their entries added to the remote debug device configuration file. They'll be told to register their device with a name before they can chat.
The remote debug chat is started along with the remote debugger for nice chatting experience:
Socket: TCP
Port: 3015 (configurable)
Transfer: Inbound and Outbound
Pressing ENTER on the chat connection will post a message to the kernel debugger if chat recording is enabled, causing everyone who connected to the remote chat part of the remote debugger to see the message live.
The debug writer class provides you functions that allow you to write your debugging messages to the devices that are connected to the remote debug session. There are two types of the functions:
WriteDebugDeviceOnly() writes your debugging message to a device that is connected to the remote debug facility.
WriteDebugDevicesOnly() writes your debugging message to the devices that are connected to the remote debug facility.
WriteDebugChatsOnly() writes your debugging message to the devices that are connected to the remote debug chat.
You can establish a connection to the remote debugger using or an equivalent software. Once you install this, fill the below forms to make a connection:
